Kenwood P907, Instruction Manual

Page: 11 / 44

Setting On Screen Display Function:(see p.16)
Touch the [ On Screen ] to switch the on screen function auto " AUTO "
and manual " MANUAL ".
" AUTO " :When a button on the main unit or remote control unit is
operated or if the lower center of the screen is touched while a
TV/video picture is displayed, the audio source, picture settings, video
out settings, etc., are temporarily superimposed on the picture.
" MANUAL " :If the lower center of the screen is touched while a
TV/video picture is displayed, the audio source, picture settings, video
out settings, etc., are superimposed on the picture. The display turns
off when the lower center of the screen is pressed again.
Setting the Pointer Display Function:
When the graphic screen is touched, the pointer display setting
switches between “TYPE-1”, “TYPE-2” and “OFF” (no pointer is
displayed) each time [ Point Marker ] is touched.
Setting Country: (Displayed for PAL products only)
Touch [COUNTRY] to select the channel setting for your country as
follows.
“China”
: China area (excluding the Hong Kong area)
“Hong Kong” : Hong Kong area
“Indonesia”
: Indonesia area
“Other” : Singapore, Malaysia, Thailand, Philippines, Brunei area
About the PAL-NTSC switch on your video CD decoder unit
• PAL type models should be set to “PAL”
• NTSC type models should be set to “NTSC”
Ending System Setting Screen:
Touch the [ RTN ] to return the menu screen.
NOTE
English
11
SYSTEM
TOUCH
CLOCK
RTN
TYPE-1
Point Marker
AUTO
OnScreen
RDS
Hong Kong
COUNTRY
FM
FM
Pointer TYPE-1
Pointer TYPE-2
FM-TX
87.5
MHz
Touch the [ < ] to
decrease the
frequency by one
step. Touch the [ > ] to
increase the
frequency by one
step.
FM Transmitter ON/OFF switch:
If the A907 is not connected, you can use the FM transmitter function to
hear the audio from the TV, video or CD played from your car radio.
Touch [FM-TX] to toggle the FM transmitter function on and off.
When the A907 is connected this function is not displayed.
FM Transmitter Frequency Switching:
When the FM transmitter function is turned on, you can switch the
transmission frequency as follows
NOTE
• Be sure to select a frequency that is not the same as a broadcast
station in your area.
• The “Auto Seek” function on your car radio may not stop at the
FM transmitter frequency. In this case, use the “Manual Seek”
function to set the radio to the FM transmitter frequency.
• If the hideaway unit is grounded the audio signal from the FM
transmitter may be difficult to hear.
NOTE