(No.RA003<Rev.004>)1-21
5.2
REALIGNMENT
5.2.1 Modes
5.2.2 How to Enter Each Mode
5.2.3 PC Mode
5.2.3.1
Preface
The transceiver is programmed by using a personal computer, a
programming interface (KPG-22A/22U) and the FPU (program-
ming software).
The programming software can be used with a PC. Figure 1
shows the setup of a PC for programming.
Fig.1
5.2.3.2
Connection procedure
(1) Connect the transceiver to the computer using the interface
cable.
Note:
You must install the KPG-22U driver in the computer to
use the USB programming interface cable (KPG-22U).
(2) When the Power is switched on, you can immediately enter
user mode. When the PC sends a command, the transceiv-
er enters PC mode.
When data is transmitting from the transceiver, the red LED
lights.
When data is being received by the transceiver, the green
LED lights.
Note:
• The data stored in the computer must match the “Mod-
el Name and Model Type” when it is written into the
EEPROM.
• Do not press the [PTT] key during data transmission or
reception.
Mode
Function
User mode
For normal use.
PC
mode
Used to communication between the
transceiver and PC.
Data programming
mode
Used to read and write frequency data and
other features to and from the transceiver.
PC test mode
Used to check the transceiver using the
PC. This feature is included in the FPU.
Wireless clone
mode
Used to transfer programming data from
one transceiver to another.
Mode
Operation
User mode
Power ON
PC mode
Received commands from PC
Wireless clone
mode
[PTT] + [Side2] + Power ON (Two seconds)
User mode
Data programming mode
PC test mode
PC tuning mode
PC mode
Wireless clone mode
PC
KPG-22A or KPG-22U
FPU
Tuning cable
(E30-3216-05)
Gray
Gray/Black
1.5D-XV Lead wire
1.5D-XV Shield wire
+
–
+
–
SP
MIC
D-SUB
(9-pin)
KPG-22A
PC
Transceiver
Transceiver
USB
KPG-22U
PC
