24
|
LZH-D120B/LZH-D120G
Lamp Cover
2
. Attach the metal support bracket
to the
ceiling support beam (s) of your vehicle by
using the supplied screws
. Take extra
care not to penetrate the roof of your
vehicle.
3
. Connect the wiring harness (according to
the diagram under “Connecting Wires to
Terminals” to the wires located in the dome
light of your vehicle.
4
. Befor installing the unit to the ceiling, it
is recommended to setup FM antenna
as shown on the figure. FM antenna
is
helpful for increasing the FM signal and
lowering noise in audio. Please stretch
antenna cable towards the on-vehicle radio
antenna.
5
. Open the monitor screen down, and you
can flip the monitor screen down, and you
can find the screw holes inside dome Lamp
covers area and on the unit. Screw the
unit to the support bracket by using the
supplied screws
or
. After installation,
Please make sure to place the lamp covers
attach the unit.
Regarding to Trim Ring, a user can choose either
of the below installation methods.
Case A. Installation with Bracket only.
Case B. Installation with Bracket and Trim Ring.
(Using Trim Ring recommended).
Direction of rear seat
Please locate this part of the
bracket
in this direction.
Direction of front seat
Screw
Bracket
Screw
or
Trim Ring
FM Antenna
Installatio
(Professional installation recommended)
LZH-D120_Eng_0902.indd 24
2010-09-02 �� 3:29:29