English
|
103
General
?
The power does not turn on.
✔
The fuse has blown.
After checking for short circuits in the wires,
replace the fuse with one having the same
rating.
✔
The speaker wire has a short-circuit or touches
the chassis of the vehicle, and then the
protection function is activated.
Wire or insulate the speaker cable properly and
press the reset button.
?
The desired source is NOT selected although
you pressed the SRC button.
✔
A non-connected source cannot be selected.
A non-connected source is not selected. See
<INSTALLATION MANUAL> and connect the
unit correctly.
✔
The RESET button is not pressed yet although
the optional unit has been connected to the
system.
Press the reset button (page 4).
✔
The "O-N" switch of the optional unit is at the
"O" position.
Set the "O-N" switch to the "N" position.
✔
A disc changer not supported by the system is
used.
Use a disc changer supported by the system
(page 4).
?
The message "Disconnected cable found.
Please confirm a connection line" is displayed
and the unit cannot be used.
✔
Receiver unit is disconnected.
Connect the wire correctly, referring to the
section on <INSTALLATION MANUAL>.
?
Nothing happens when the buttons are
pressed.
✔
The computer chip in the unit is not
functioning normally.
Press the reset button on the unit (page 4).
?
No television/video image appears.
✔
The unit is not connected to the parking brake
detection switch.
Make proper connections according to
<INSTALLATION MANUAL>.
✔
The parking brake is not engaged.
For safety reasons no television/video images
are displayed while the vehicle is moving.
Engaging the parking brake will cause images
to be displayed.
?
The screen is dark.
✔
The unit is in a location where temperature is
low.
If the temperature of the monitor unit drops,
the screen may appear darker when power is
first turned on due to the characteristics of a
liquid crystal panel. Wait a while after turning
power on for the temperature to rise. Normal
brightness will return.
?
The screen does not darken when the vehicle’s
lights are turned on.
✔
The unit is set to auto dimmer.
When the unit is set to auto dimmer, it is not
linked to the vehicle's light switch.
✔
The illumination wire has not been connected.
(If manual dimmer is set)
Make proper connections according to
<INSTALLATION MANUAL>.
?
AM/FM radio reception is poor and/or there is
noise.
✔
The TV antenna and vehicle‘s radio antenna are
too close.
Separate the two antennas as far as possible.
Turn off the main unit.
?
The remote controller does not operate.
✔
The remote control mode selector is not set
correctly.
Switch the remote control mode selector
according to the source you select (page 12).
?
No sound can be heard, or the volume is low.
✔
Attenuator is turned on.
Turn off Attenuator.
✔
The fader or balance settings are set all the
way to one side.
Reset the fader and/or balance settings.
✔
The input/output wires or wiring harness are
connected incorrectly.
Reconnect the input/output wires or the
wiring harness correctly. See the section on
<INSTALLATION MANUAL>.
What might appear to be a malfunction in your unit may just be the result of slight misopera-
tion or miswiring. Before calling service, first check the following table for possible problems.
B64-3171-00̲00̲K̲En.indd 103
B64-3171-00̲00̲K̲En.indd 103
05.5.25 2:03:37 PM
05.5.25 2:03:37 PM
