GB-26
starting a wash cycle
Please follow the steps below to start a wash cycle.
Ensure the unit is connected to the mains power and the water supply
is fully opened (water pressure between 0.0MPa and 1.00MPa).
Open the door. Pull out the lower and upper baskets, load the dishes
and push the baskets back. It is recommended that the lower basket is
loaded first, and then the upper basket.
Pour in the detergent or place the detergent tablet in the detergent
compartment. Ensure the lid is firmly closed afterward.
Do not slam the dishwasher door. A click sound should be heard
when the door is closed correctly.
Press ON/OFF button.
Select the wash cycle programme based on the loading and soil re-
quirements. Please refer to the “Wash Cycle Table” (page 15).
The indicator light of the selected programme will illuminate.
The washing cycle will begin shortly.
NOTE:
If you open the dishwasher’s door during the washing cycle and
then close it, the dishwasher will continue the current washing programme
after 10 seconds. However, if the door is not closed correctly after 1 min-
ute, the dishwasher will make an audible sound at 1 minute intervals.
changing a programme
To change the programme if the washing cycle has already started, please
follow the steps below.
Open the door slightly to check if the unit has dispensed the deter-
gent or detergent tablet. This will depend on how long the washing
cycle was running for.
If the detergent dispenser lid is opened, we suggest you to allow the
wash cycle to complete.
If the detergent dispenser lid is still closed, press and hold down the
current programme button for 3 seconds to cancel the programme.
You may then close the dishwasher door and press the required new
programme button. The unit will start the new washing cycle shortly.
1.
2.
3.
.
5.
6.
7.
8.
1.
2.
3.
Kenwood KS474S_IB_GB_090828.indd26 26
28/08/09 12:25:53 PM
