— 41 —
Removing the hard rubber frame
■
Engage the catches on the removal tool
2
and remove the tw o
locks on the low er level, leaving the removal tool
5
inserted on
the upper level.
Use the removal tool facing the side covered w ith the
protective sheet to the faceplate.
Low er the frame and pull it forw ard as show n in the figure.
2
You w ill feel (not hear) a click w hen the tabs lock securely.
N OTE
Insert the removal tool
5
deeply w ith the cut placed to the
right to remove the upper locks at an angle as show n below .
1
Rem oving t he U nit
Lock
Accessory
5
Removal tool
Catch
Lock
Accessory
2
Removal tool
Cut
Removing the Unit
■
Accessory
3
Push dow nw ard on the left-
hand tool and the upw ard
on the right-hand tool, as
show n, and pull the unit
tow ard you until it is
halfw ay out. The unit may
drop if you pull it out
completely.
4
Pull the unit all the w ay out
w ith your hands, being
careful not to drop it.
5
Be careful to avoid injury from the catch pins on the removal tool.
2
CA U TION
Refer to the section “ Removing the hard rubber frame” and
then remove the hard rubber frame.
Remove the hex head machine screw w ith w asher (M 4
×
8) on
the back panel.
Insert the tw o removal tools at an angle and push them deeply
into the slots on each side, as show n.
3
2
1
Accessory
2
Removal tool
http://www.usersmanualguide.com/
