English
— 36 —
— 36 —
8 mm
MAX.
ø5mm
ø5mm
8mm
MAX.
■
Installing in Japanese-Made Cars
T: Toyota cars
N: Nissan cars
T
N
N
T
T/N
Accessory
3
...for Nissan car
Accessory
4
...for Toyota car
• During installation, do not use any screws except for those provided.
The use of different screws might result in damage to the main unit.
• Damage may occur if a screwdriver or similar tool is used with
excessive force during the installations.
1
Refer to the section <Removing the hard rubber frame> (page
37) and then remove the hard rubber frame.
2
Align the holes in the unit (two locations on each side) with
the vehicle mounting bracket and secure the unit with the
accessory screws.
3
4
Installation
■
Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it
does not fall off.
1
Refer to the section <Removing the hard rubber frame> (page
37) and then remove the hard rubber frame.
2
Drop open the faceplate by pressing the Release button.
Never insert the screws in any other screw hole than the one specified.
If you screw them in another hole, it will contact and may cause
damage to the mechanical parts inside the unit.
4
Tighten the screw (ø2
×
4 mm) (Accessory
6
) in the hole
shown on the diagram.
Accessory
7
5
Tighten the screws (ø2
×
6 mm) (Accessory
7
) in the holes
shown on the diagram.
Accessory
6
3
Tighten the screw (ø2.6
×
12 mm) (Accessory
5
) in the hole
shown on the diagram.
Accessory
5
KRC-766(M)_U.S_r2 02.11.11 7:51 PM Page 36
Summary of Contents for KRC-666
Page 42: ...KRC 766 M Eng r3 Page 42 ...
