- 3 -
Steps to Install the KNA-G610
1.
Remove the key from the vehicle ignition and disconnect
the negative battery cable.
2.
Install the GPS antenna. Refer to the tips on the
previous page.
3.
Connect the wiring harness to your vehicle in the
following order: ground, battery
, ignition.
4.
Connect the wiring harness to the
main unit.
5.
Install the main unit. Refer to the tips on the previous
page.
6.
Reconnect the negative battery cable.
To
mount the GPS antenna inside your vehicle:
1.
Clean your dashboard or other surface.
2.
Peel the backing of
f of the adhesive on the bottom of the metal
plate.
3.
Press the metal plate down
fi
rmly on your dashboard or other
mounting surface.
Yo
u can bend the metal plate to conform to a
curved surface, if necessary
.
4.
Place the GPS antenna on top of the metal plate.
n
n
CAUTION
If your vehicle ignition does not have an
ACC position,
connect the ignition wires to a power source that can be
turned on and of
f with the ignition key
. If you connect the
ignition wire to a power source with a constant voltage
supply
, such as battery wires, the navigation system could
drain your battery
.
n
n
W
ARNING
Do not connect the yellow wire directly to
the vehicle battery
. Connecting directly to
the battery may cause the wire insulation
to fail and may pose a risk of short circuit
and electric shock.
Optional accessory:
FM traf
fi
c
receiver
SD card
GPS antenna
To
display unit (NA
V I/F terminal)
Black
To
vehicle chassis
Red
To
ignition (12 Vdc)
Y
e
llow
To
battery (12 Vdc)
Car fuse box
(main fuse)
Car fuse box
Ignition key switch
Installing the GPS
Antenna
Better (trunk
of vehicle)
Best (roof of vehicle)
Good (inside c
ar
on dashboard)
NOTE
: The 2010 and later display unit
can be connected to this system.
T
o
check the connectable models, go to
www
.kenwood.com/cs/ce.
2A
2A
190-01159-02_0A.indb 3
190-01159-02_0A.indb 3
1/8/2010 8:45:14 AM
1/8/2010 8:45:14 AM
