Reset
When installation is complete, check the connections.
If everything is in order, press the reset button. If the
unit does not seem to be working right, try pressing
the reset button first.
If that does not solve the problem, consult your
Kenwood dealer.
The Mark Position of Your Car Immediately After Installation
• Immediately after installation, the information of the GPS satellite is taken in and it may take
several minutes to measure the position of the current location.
• Immediately after installation, the initial value setting of the gyro sensor is required. After
measuring the position of the current location, drive of about 6.2 mile (10 km) and further at a
constant speed at least 24.8 mile/h (40 km/h) in a place where there are few obstacles (for
example, buildings and tree-lined streets).
• Until the initial values are set, the position and speed indication of you car's mark on the navigation
system may differ greatly from the actual values.
• The proper connection of the car speed signal wire can be checked with the menu screen. Please
see the instruction manual for details.
NOTE
Installation Procedure
To prevent short circuits, remove the key from the ignition and disconnect the
·
battery.
Make the proper input and output wire connections for each unit.
Connect the wiring harness wires in the following order: ground, battery, ignition.
Connect the wiring harness connector to the unit.
Install the unit in your car.
Reconnect the
·
terminal of the battery.
Press the reset button.(See page 3)
6
6
5
4
3
2
1
• If your car's ignition does not have an ACC position, connect the ignition wires to a power source
that can be turned on and off with the ignition key. If you connect the ignition wire to a power
source with a constant voltage supply, as with battery wires, the battery may die.
• If the fuse blows, first make sure the wires aren’t touching to cause a short circuit, then replace
the old fuse with one with the same rating.
• Do not let unconnected wires or terminals touch metal on the car or anything else conducting
electricity. To prevent a short circuit, do not remove the caps on the ends of the unconnected
wires or the terminals.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the car are
working properly.
• Insulate unconnected wires with vinyl tape or other similar material.
2
CAUTION
English
-
3
KNA-DV3100Inst(K)_En 03.5.8 10:06 AM Page 3
