— 55 —
?
There’s no Front High Pass Filter and Rear High Pass Filter effect.
31
✔
The Non-fading preout is being used.
☞
There’s no effect in Non-fading preout.
?
The Touch Sensor Tone doesn’t sound.
34
✔
The preout jack is being used.
☞
The Touch Sensor Tone can’t be output from the preout jack.
?
Even though Synchronize Clock is ON, the clock can’t be adjusted.
35
✔
The received RDS station isn’t sending time data.
☞
Receive another RDS station.
?
The Dimmer function doesn’t work.
38-1
✔
The Dimmer wire isn’t connected correctly.
☞
Check the Dimmer wire connection.
?
The panel is not hidden even when the power is turned off.
38-3
✔
The protection function for preventing fingers or other things from
getting caught in between the panel and this unit has been activated.
☞
Turn off the power again.
?
Sound is interrupted when Dual Zone System is set to ON.
38-4
✔
When Dual Zone System is set to ON while the Menu system’s <AF
(Alternative Frequency)> (page 43) is set to ON, the sound quality
may be adversely affected if the internal source is set to the tuner.
☞
---
?
There are no audio control effects.
✔
WOW item on <Audio Control> (page 10) and SRS WOW item on
<System Q> (page 10) have no effect in rear output.
☞
---
Tuner source
?
Radio reception is poor.
39
✔
The car antenna is not extended.
☞
Pull the antenna out all the way.
✔
The antenna control wire is not connected.
40
☞
Connect the wire correctly, referring to the section on
<Connecting Wires to Terminals>.
?
The desired frequency can’t be entered with the Direct Access
Tuning.
41
✔
A station that can’t be received is being entered.
☞
Enter a station that can be received.
✔
You’re trying to enter a frequency with a 0.01 MHz unit.
42
☞
What can be designated in the FM band is to 0.1 MHz.
?
It isn't the set Traffic information sound volume.
43
✔
The set sound volume is less than the tuner sound volume.
☞
If the tuner sound volume is louder than the set sound volume,the
tuner sound volume is used.
Disc source
?
"AUX1" is displayed without achieving External disc control mode.
50
✔
Unsupported disc changer is connected.
51
☞
Use the disc changer mentioned in the IMPORTANT
INFORMATION of the section on <Safety precautions> (page 3).
?
The specified disc does not play, but another one plays instead.
52
✔
The specified CD is quite dirty.
☞
Clean the CD.
✔
The disc is loaded in a different slot from that specified.
54
☞
Eject the disc magazine and check the number for the specified
disc.
✔
The disc is severely scratched.
55
☞
Try another disc instead.
?
A CD ejects as soon as it is loaded.
62
✔
The CD is quite dirty.
63
☞
Clean the CD, referring to the CD cleaning of the section on
<About CDs> (page 5).
KDC-9023R_U.S_r4.pg 02.12.9 6:03 PM Page 55
