9
4.
Perform the cord wiring work.
Refer to "How to Wire" and then
perform the wiring work.
5.
Adjust the installation angle of
the device and then fix the device
in place.
Turn the angle adjustment knob
clockwise before adjustment. Adjust
the sky portion and the road portion
to 50:50 as shown in the picture below.
After adjusting the installation angle,
turn the angle adjustment knob of the
adjustment bracket counterclockwise
to fix the device in place.
■
Adjustment example
Angle adjustment knob
Windshield
Rear-view mirror
6.
Adjusting the Settings to Match
the Vehicle
• Settings are required to use the driving
support function.
The driving
support function will not work without
configuring these settings properly.
• Configure the Dashboard camera on
the receiver on which the device is
connected. For connection information,
refer to the instructions supplied with
that receiver.
Recommended installation position
• Install the device in a position where it will not block the front view of the driver
(position where hidden by the rear-view mirror).
• Install the device so that it is within the wiping range of the wiper.
• Mounting the device to the center of the windshield behind the rear-view mirror will
facilitate optimal video recording.
Windshield
Ceramic part
CAUTION
When passing the power cord through the front pillar or another part, observe the
following points when performing the wiring work.
• Wire the power cord farther forward or farther rearward than the airbag so that it does not
interfere with the airbag.
• In the case of a vehicle in which the front pillar cover is fixed in place with special clips or the like,
the clips may need to be replaced after you remove the front pillar cover. For how to remove the
front pillar cover, the availability of replacement parts, and other information, contact the vehicle
dealer.
• Fix the power cord in place with commercially available soft tape or the like so that it does not
interfere with driving.
Double-sided tape
Inside
vehicle
Front pillar
cover
Clip
Airbag
Front pillar
Power cord
1
Soft tape*
Rear-view mirror
Power cord
1
*Fix the power cord in place with commercially available
soft tape or the like.
Outside
vehicle
Example of Mounting
DRV-N520W_EN301.indd 9
2017/03/08 14:05
