■
Recording from a tuner or a CD (Manual recording)
●
Manual recordings can be started and stopped as you like.
Recordings can not be made in the
following situations:
●
Recording on a playback-only Mini-
Disc (commercially available music)
●
If a Minidisc is protected against ac-
cidental erasure (page 12)
About the recording level:
●
If the recording level is too low, the
playback sound volume may be too
low to hear well. If it is too high, the
playback sound may be greatly dis-
torted. Since digitally recorded CDs
have a large dynamic range (the vo-
lume can vary tremendously from
very soft to extremely loud), do not
set the recording level any higher
than is necessary.
Precautions when recording:
●
Do not jar or bump the main unit
whilst recording. Otherwise, the re-
cording may be unusable.
●
Depending on the strength and type
of playback signal in the original re-
cording, the new recording may not
begin or pause at the correct point
when in the synchro mode. If this
happens, try making a manual recor-
ding.
Precautions when inserting a Mini-
Disc:
●
To insert a Minidisc, push on the
middle of the edge of the disc whilst
holding it parallel to the main unit.
●
If any resistance is felt, do not try to
force the MiniDisc into the unit. It
may cause more problems. If resis-
tance is felt, remove the MiniDisc
and try reloading it.
Notes:
●
Whenever any button is pressed, the
remote control display will light for
about 4 seconds.
●
The RECORDING button does not
light.
1
Put the unit in the recording stand-by
mode. (Perform steps 1 - 4 in the “Syn-
chro recording” section.)
2
Press the
38
button.
●
Recording will start.
●
To record from a CD, press the
38
button, and then start playback on the
equipment connected to this unit.
●
Track numbers can be created whilst
recording. (Page 20)
To interrupt recording:
Press the
38
button whilst recording.
●
The unit will enter the recording stand-
by mode.
●
To resume recording, press the
38
button again.
The track number will be increased by
one each time you interrupt a recor-
ding.
To stop recording:
Press the
■
/ OFF button.
●
If the unit is left alone after the recor-
ding has stopped, the power will be
turned off about 2 minutes later.
After recording:
Press the
■
/ OFF button whilst in the stop
mode.
●
After the track number has been written
on the disc, the power will be turned off
automatically. (For details about the
TOC, see page 23.)
To remove the MiniDisc:
Turn off the power and move the EJECT
lever in the direction indicated by the ar-
row.
14
DMC-J7R
Summary of Contents for DMC-J7R
Page 45: ...MEMO ...