Installation and Connection
Installation and Connection
7
Reconnect the
·
battery.
8
Press the reset button on the monitor
panel. (Page 4)
9
Configure <Initial Settings>. (Page 5)
Installing the unit
Select the appropriate type of screw for the mounting
bracket: flat head (
[
) or round head (
“
).
Installing the trim plate
(Only for DDX4018BT)
Parts list for installation
Note:
This parts list does not include all the package
contents.
¥
Wiring harness (× 1)
ø
Extension wire, 2 m (× 1)
π
Microphone, 3 m (× 1)
[
Flat head screws (M5 x 8 mm) (× 6)
“
Round head screws (M5 x 8 mm) (× 6)
]
Steering Remote cable (× 1)
Only for
DDX4018BT
:
‘
Trim plate (× 1)
Installation procedure
1
Remove the key from the ignition and
disconnect the
·
battery.
2
Make the proper input and output wire
connections for each unit.
3
Connect the speaker wires of the wiring
harness.
4
Connect the wires of the wiring harness
in the following order: ground, battery,
ignition.
5
Connect the wiring harness connector to
the unit.
6
Install the unit in your car.
Make sure that the unit is installed securely in place.
If the unit is unstable, it may malfunction (e.g., the
sound may skip).
Connecting external components
1
Navigation input (NAV)
2
Steering wheel remote controller input (REMO-IN)
• Connect to the car’s steering remote harness.
Contact your KENWOOD dealer for details.
3
Microphone input (MIC) (Page 46)
4
Audio video input (AV-IN)
Connect the following type of 4-pole mini plug:
1
Left audio
2
Right audio
3
Ground
4
Composite video
5
Video output (V-OUT)
6
Rear view camera input (R-CAM)
7
Output terminals*
• Left output (White)
• Right output (Red)
REAR: Rear speaker preouts
FRONT: Front speaker preouts
SW: Subwoofer preouts
* When connecting an external amplifier, connect its ground wire
to the chassis of the car; otherwise the unit may be damaged.
Car bracket
45
ENGLISH
00_DDX418BT_MN_ENG.indb 45
00_DDX418BT_MN_ENG.indb 45
13/6/2017 10:26:36 AM
13/6/2017 10:26:36 AM
