36
FZDA07ELEF2/EREF2/MRHF2
•
When ACC tur ns on (OFF
→
ON) at 1 hour 59
minutes, keep counting from that timing (1 hour 59
minutes)
•
When ACC is reset at 1 hour 59 minutes, keep
counting from 1 hour 00 minute.
7
Number of disc ejection (AUDIO)
∗
The display shall be updated every time when there
is any change in the data.
• Count from 0 to 60000 times.
• Record the number by the count in E2PROM.
8
Number of disc ejection (MAP)
∗
The display shall be updated every time when a
screen is shifted to other screen.
At Audio side;
• Count from 0 to 60000 times.
• Record the number by the count in E2PROM.
9
Number of panel mechanism operations (open and
close)
∗
The display shall be updated every time when a
screen is shifted to other screen.
At Audio side;
• Count from 0 to 60000 times.
• Record the number by the count in E2PROM.
•
When the panel is fully opened, it is counted as one
time (one count).
A
Return to “Audio Diag Menu” screen.
B
AMP Power ON Time clear key
E DC offset detection/Number of DC offset detection
clear key
F
Disc operation time (AUDIO) clear key
H Number of disc ejection (AUDIO) clear key
J
Number of panel mechanism operations clear key
■
Vehicle Signal Info. screen
• Display CAN connection status.
• Display connection status in vehicle signal.
• Display connection status of the GPS Antenna.
∗
1 When the equipment is connected it is shown in blue and
when not connected it is shown in red.
This display shall indicate the status.
∗
2 Unlike the Maker Line Diag, the ON/OFF condition of
the vehicle speed shall be such that the vehicle speed is
turned ON when the vehicle speed reaches the forced
running by the navigation.
Menu
Vehicle Signal Info.
NAVI Unit
•
GPS
Antenna Connect
CAN Signal
•
CAN
OK
•
BCU
OK
•
Meter
OK
•
Air-Con
NG
Vehicle Signal
•
Illumination
OFF
•
Speed
OFF
•
Reverse
ON
•
IGN
OFF
•
Parking
ON
A
1
2
3
4
5
6
7
8
9
10
11
12
13
14
●
Description of operations
1 Title
2
3
Display connection status of the GPS Antenna.
4
5
Display CAN Unit line information.
6
Display Body Control Unit status.
7
Display Meter Unit status.
8
Display Air-Con status.
9
10 Display illumination status in vehicle signal.
11 Display vehicle speed information in vehicle signal.
12 Display reverse status in vehicle signal.
13 Display ignition status in vehicle signal.
14 Display parking status in vehicle signal.
A
Return to “Engineering Diag Menu (Page3)” screen.
■
Touch Panel Adjust screen
∗
The correction mark shall be designed such that the center
point can be identifi ed clearly (such as +, X, etc).
Modifi ed for 4-point touch correction.
RESET
Menu
1
Touch Panel Adjust
A
B
C
D
E
F
●
Description of operations
1 Title
Touch correction shall be made in the following order
of the sequence: “Lower left correction
→
Upper light
correction
→
Upper left correction
→
Lower right
correction”
E Shift to “Engineering Diag Menu (Page3)” screen.
(Touch correction reset)
TEST MODE