10
Notes:
1.
If any parameter would take the MIDI output outside the available range then the output will be the
highest (127) or lowest note (0) available and maximum/minimum pitchbend range as applicable.
2.
Numbers over 1000 are not accessible from the front panel but can be set by the autotune function,
these are displayed with three horizontal lines in the left digit followed by the two least significant digits.
3.
A440 mode is intended to be used with pitchbend range set to 48 (4 octaves up and down). However
not many receiving devices can be set to pitchbend range of 48. It is however usable with pitchbend
range of 12, giving a range of 24 notes, 12 up and 12 down from A (MIDI note 69) You can still use the
transpose feature to shift the centre note.
4.
As of firmware version 1050, the Autotune feature works fully for 1V/Oct and 1.2V/Oct and sets up
all relevant parameters. You might however want to adjust the transpose to suit personal taste.
Hz/V will be recognised and selected, however for Hz/V you might still need to tweak the results using
the fine tune, scale, linearity and transpose parameters.
5.
When using the Aux1 or Aux2 for Clock or Stop/Start it is important to set the Min & Max values.
They should both be set the same at half of the incoming voltage. For a 5V clock source this is 25.
RESETTING THE PRO CV to MIDI TO FACTORY DEFAULTS
If you wish to reset your
PRO CV to MIDI
to its default settings, you can do so by turning the unit on
whilst holding down all three push buttons. When this has been completed [Fd] (factory defaults) will be
displayed. You can then release the buttons.
CHECK LIST FOR SETTING UP THE PRO CV to MIDI
1.
Make sure all cable connections have been made.
2.
Set MIDI receive channel you wish to use.
3.
Make sure you have set the GATE input correctly to either `Gate`
or `S-Trig` type triggers.
4.
Make sure you have set the CV input correctly to either `V/oct`
or `Hz/V.`
5.
You may wish to adjust the AUX, or any other settings to those that
work best for your set-up.
DISPLAYING THE SOFTWARE VERSION NUMBER
Power on the
PRO CV to MIDI
whilst holding the
INC
button pressed and the software version [1xxx]
will be displayed in 3 groups eg 10 50 ---. Releasing the buttons will revert to the normal operational
mode.
UPDATING THE FIRMWARE OVER MIDI
Disconnect the MIDI plug from the DIN socket on the PRO CV to MIDI.
Set parameter 90 to ‘MIDI IN’ –
see page 9
.
Connect the
Pro
CV to MIDI’s
MIDI port to the MIDI output of your MIDI interface.
Follow the firmware update instructions included with the update.
The MIDI port will revert back to MIDI OUT on power-up.
