Product Manuals/Man-1099_Syncro_Si_Status_Unit_05
2
1. Introduction
Syncro Si Status units and Hold off units allow control and indication of the essential functions of the
Syncro XT gas extinguishing system by connecting to any point on the Apollo protocol analogue
addressable fire detection and alarm loop wiring.
Status units are available with indicators only, with a manual release control or with a manual
release and mode select controls.
Hold off units are available in surface mounting enclosures.
The ability to connect to any point on the analogue addressable fire detection and alarm loop wiring
offers convenience and cost saving as additional wiring does not need to be fitted from these points
back to the control panel.
Status units and Hold off units can simply be fitted and added to the system via the Loop Explorer
configuration programme.
They will automatically carry out the required actions without any additional configuration being
required.
2. Safety
Suppliers of articles for use at work are required under section 6 of the Health and Safety at Work
act 1974 to ensure as reasonably as is practical that the article will be safe and without risk to
health when properly used.
An article is not regarded as properly used if it is used ‘without regard to any relevant information or
advice’ relating to its use made available by the supplier.
This product should be installed, commissioned and maintained by trained service personnel in
accordance with the following:
(i)
IEE regulations for electrical equipment in buildings
(ii)
Codes of practice
(iii)
Statutory requirements
(iv)
Any instructions specifically advised by the manufacturer
According to the provisions of the Act you are therefore requested to take such steps as are
necessary to ensure that you make any appropriate information about this product available to
anyone concerned with its use
