3
3. Fix the heater to the wall by locating the
bracket holes over the screws then secure
in place by slotting the screw into the
upper most fixing location on the bracket
(slide to the right and up).
4. Ensure the heater is securely fastened to
the wall.
Positioning of the Heater
Portable: The appliance should only be
operated at a minimum distance of 1 metre
from any wall or other object. Position the
heater in order to optimise the air flow of the
room.
Wall-mounted: refer to the drawing below for
minimum clearances.
MINIMUM CLEARANCES
ASSEMBLY INSTRUCTIONS
This heater is supplied with both wall mounting
brackets for fixed installation and castors for
portability.
Portable Assembly
1. Position the heater carefully upside down
and position the base supports over the
screw hole in the base of each end of the
heater.
2. Secure with the 2 screws supplied
(1 screw per base support).
Fixed Installation
Refer to Minimum Clearances adjacent as a
guide to the correct location of the heater.
Ensure the castors are removed and stored
safely, if they are currently secured to the
heater.
1. Secure the 3 mounting
brackets to the rear of the
heater by locating the top
of each bracket into the 3
slots. Fix each bracket at the
base with the 3 small screws
provided.
2. Note: The bottom bracket is not required
to be affixed to the wall. It is a spacer to
balance the heater when affixed.
Use the correct type of fixing method to fix
the screws to the wall (2 long screws and
raw plugs are included with the heater). To
ensure the most secure location, affix to a
stud.
200mm
Minimum
100mm Minimum
100mm
Minimum
Socket
Appliance
W
all
Floor
The distance between two
screws is 500mm
Top
Bottom
Summary of Contents for KPE216-147
Page 8: ...8 ...
