background image

5

6

Use  white  pipe  for  raw  water  supply.

When the water cooler’s storage tank gets filled up completely the 
float in the cooler will cut off  the RO purified water supply from 
KENT Elite Plus -New. This will further create a water pressure. In 
turn the high pressure sensor installed in the machine will cut off  
the electric supply to the machine. The purification of  KENT Elite 
Plus-New will automatically start again as soon as the water level 
drops.

ELECTRICITY

WATER
SUPPLY

REJECT WATER

RO WATER

WATER COOLER

TO FLOAT

Use  blue  pipe  for  reject  water.

KENT Elite Plus-New is de

signed to facilitate wall mounting as well as counter-top purification. 

It is easy and convenient to install.

Recommended Site Preparations:

n

 

Single phase 100-250 V AC, 50-60 Hz. supply not more than 3m away from the point of  

installation

n

 

Raw water supply with ½  inch nipple not more than 3m away

n

 

Drain for reject water not more than 3m away

n

 

Installation space as per the dimensions of  the purifier

n

 

For  proper  installation,  make sure  that  the  purifier  is  mounted  on  a  wall  surface. Avoid 

installation on wooden and metallic stands

n

 

For optimum inlet pressure, source water tank should be at least 10 ft. above the purifier 

installed

Installation  Instructions

Automatic  Operation

n

The purifier automatically shuts off  when the tank is full.

2

n

The purifier does not start when inlet water supply pressure fall below 0.3kg/cm

n

The purifier automatically restarts when the water level drops below the maximum level

n

The purifier does not allow any water rejection in absence of  electricity/when tank is full

n

The purifier automatically flushes & cleans the RO membrane on periodic intervals

234mm

* Tested  &  Certified  by TUV-SUD  South  Asia  (P)  Ltd.

Installation Procedure:

 1.   Screw  in  two  10x50  self   taping  screws,  234  mm  apart 

horizontally. 

 2.   Wall-mount the purifier with the help of  slot holes given on back 

side.

 3.   Fasten the SS ball valve to

 ¼ 

inch port of  3-way connector.

 4.   Attach  the  threaded  end  of   3-way  connector  to  raw  water 

supply and plug off  the other end or connect to a tap.

 5.  Now  connect  one  end  of   white  pipe  to  SS  ball  valve  and 

the  other  end  to  lower  elbow  fitting  connector  labeled  as 

WATER  IN

,  on  the  bottom  of   purifier.       

 6.  Connect  one  end  of   blue  pipe  to  upper  elbow  fitting  connector  labeled  as 

REJECT 

WATER 

and  lead  the  other  end  to  drain.        

.

 7.  Connect the purified water pipe to the water cooler.

 8.  Turn on the lever given on SS ball valve to initiate the water flow to purifier.

 9.  Allow the filters to pre-soak in the water for 2-3 minutes.

 10.  Connect  the power  supply. 

11.  Installation  is  complete.

UV  Fail  Alarm*

KENT Elite Plus-New Water Purifier has an in-built feature that sounds an audible alarm if the UV lamp malfunctions. 
This  feature  is  provided  to  ensure  purity.  This  UV  Fail  Alarm  will  sound as follows:

Single short beeps after every two seconds.

In  case  such  an  alarm  is  audible,  kindly  switch  off   the  purifier  and  call  the  service  technician  for  help. 
The  purifier  will  stop  its  purification  process  in  such  a  circumstance.

2  Sec.

2  Sec.

2  Sec.

2  Sec.

Filter  Change  Alarm

KENT  Elite  Plus-New  Water  Purifier  has  an  in-built  feature  that  sounds  an  audible  alarm  to  indicate 

replacement time for filters. This alarm will be audible after 700 hrs of  use since the last filter change (or since 

the time of  installation).  The  Filter  Change  Alarm  will  sound  as follows:

4 short beeps after every two seconds; for 30 seconds. The alarm will repeat after every 2 hours of  use.

In case such an alarm is audible, please call the service technician and request him to change the filters of  the 

purifier.  However,  if   the  filters  are  not  changed  within  the  next  60  hours  of   operation,  the  purifier  will  stop  

functioning to ensure purity and hygiene. The following alarm will be audible after  60 Hrs.  A continuous beep 

for an infinite time.

In  case,  such  an  alarm  is  audible,  kindly  switch  off   the  purifier  and  call  the  service  technician  to  replace 

the  filters.  In  such  a  circumstance,  the  purifier  will  not  function  unless  the  filters  are  changed.

2  Hours

30  Sec.

30  Sec.

Summary of Contents for Elite Plus-New







Reviews: