KENT C4-100A, Maintenance & Repair Manual

Page: 7 / 44

CLEANING DIRECTIONS
1) Turn all Switches OFF.
2) Disconnect the machine Solution
Hose. Pull down on the middle of the
brass Coupler. The hose will release.
While holding down the Coupler,
insert the Hand Tool Kit Solution
Hose. Release Coupler. Pull on
the Solution hose to insure it is
secured.
3) Disconnect the grey and black
Vacuum Cuffs at the back of the
machine. Connect the grey
Hand Tool Kit Cuff to the grey
machine Cuff.
WARNING: Do Not Use To Clean Haitian Cotton!
1) Read 7 IN 1 Carpet Care directions.
See: Test Colorfastness and
Upholstery Cleaning Directions.
Mix 7 IN 1 with water in Bucket
according to directions.
Note: For upholstery
cleaning, mix 1.5
gallons of cleaner
at a time.
1) Important: Pour contents of Bucket
into machine Solution Tank.
1) See Preparing Carpet & Upholstery.
2) Turn ON the Suction and Hand Tool Switches.
3) Squeeze the Hand Tool Trigger as you pull
up or back with overlapping even strokes.
Cleaning Stairs
1. Use the Hand Tool to clean stairs. (See Cleaning Upholstery to hook up hand tool.)
2. Clean the upstairs rooms first, then the stairs.
IMPORTANT: When cleaning the upper stairs, turn machine sideways so wheels are NOT facing forward, toward stairs.
Be careful bringing the machine down wet stairs. Make sure to empty the Bucket and Solution Tank using the Drain Hose.
3. Turn on Suction and Hand Tool Switches.
4. Place Hand Tool Suction Nozzle on carpet and squeeze Trigger while pulling backwards.
Cleaning Machine
1) Wipe hair and debris from the Lid.
2) Drain unused solution from Solution Tank.
3) Dispose of solution and rinse Bucket thoroughly.
4) Clean out the Vac Nozzle with a hanger.
5) Remove fibers and hair from the Brush.
6) Wipe Brush Chamber clean with towel.
7) Wipe off the exterior of the machine with a damp towel.
Spray/Brush
Trigger Switch
Suction Switch
Handle Adjust
Lid
Bucket
Handle
Bucket
Sight
Tubes
Handle
Hoses
Solution
Tank
Drain Hose
Suction Nozzle
/ Brush
4
C
le
a
n
in
g
U
p
h
o
ls
te
ry