Kenner KNL502+, User Manual

Page: 17 / 29

15
WARNING: Activate the opener only when gate is in full view, free of obstruction and properly
adjusted. No one should enter or leave gate area while gate is in motion. Do not allow children to
operate push button or remote. Do not allow children to play near the door.
Your swing gate opener receiver and remote control transmitter are set to a matching code. If you
purchase additional remote controls, the gate opener must be programmed to accept the new remote
code.
Caution: If you lose one of any remote control, please learn all other remote controls to have a new
code for safety.
The BROWN
wire of the external receiver should be connected into the “19” terminal.
The BLACK
wire of the external receiver should be connected into the “20” terminal.
The RED wire of the external receiver
should be connected into the “9” terminal.
Wired Keypad (24VDC) (optional)
The RED
wire of the wired keypad should be connected into the “9” terminal.
The BLACK
wire of the wired keypad should be connected into the “14” terminal.
The WHITE wire of the wire
d keypad should be connected into the “19” terminal.
The BLUE
wire of the wired keypad should be connected into the “20” terminal.
Solar Panel (optional)
Please refer to the manual instruction of solar panel and controller ( KNL 118) separated.
How to learn or erase the remote
Learn the remote
Press and release the learn button, the LED will display
“Ln”,
then press the key in the remote twice in 2
seconds, the LED will flash
“Ln”
for 4 seconds then back to
“- -”
. Now the remote has been learnt
successfully.
Erase all the remote codes
Press and hold the learn button until the LED
display “
dL
”, then release the learn button , the
LED will
display back to
“- -”
. Now all remote codes have been erased.