4. Perform steps in Accessing & Removing
the Electronic Assemblies, and visually
check that the P5 connector is inserted
all the way into the machine control elec-
tronics.
5. Visually check the user interface assem-
bly connections.
6. If both visual checks pass, replace the
user interface assembly.
7. Plug in dryer or reconnect power.
8. Perform the Console Buttons and Indica-
tors Diagnostic test, to verify repair.
9. If indicators still do not light, the machine
control electronics has failed:
Unplug dryer or disconnect power.
Replace the machine control electron-
ics.
Plug in dryer or reconnect power.
Perform the Console Buttons and Indi-
cators Diagnostic test, to verify repair.
No beep sound is heard:
1. Perform steps in Accessing & Removing
the Electronic Assemblies, and visually
check that the P5 connector is inserted
all the way into the machine control elec-
tronics.
If visual check passes, replace the user
interface assembly.
2. Plug in dryer or reconnect power.
3. Perform the Console Buttons and Indica-
tors Diagnostic test to verify repair.
4. If replacing the user interface assembly
failed:
Unplug dryer or disconnect power.
Replace the machine control electron-
ics.
Plug in dryer or reconnect power.
Perform the Console Buttons and Indi-
cators Diagnostic test to verify repair.
•
•
•
•
•
•
•
•
•
Some buttons do not light indicators:
1. Perform steps in Accessing & Removing
the Electronic Assemblies, and visually
check the user interface assembly con-
nections.
If visual check passes, replace the user
interface assembly.
2. Plug in dryer or reconnect power.
3. Perform the Console Buttons and Indica-
tors Diagnostics test to verify repair.
TEST #7 Door Switch
Activate the diagnostic test mode and perform
the Door Switch Diagnostic test.
Functionality is verified with a beep each time
the door is closed and opened, and a num-
ber and letter appears in the display (i.e.,
0E
,
09
).
If any of the above conditions are not met:
Unplug dryer or disconnect power.
Check that the wires between the door
switch and machine control electron-
ics are connected. See Figure 12 for
switch location, and see Removing the
Front Panel/Drum Assembly.
•
•
•
Door Switch
Figure 12.
Door switch location.
If the connections are OK, replace the
door switch assembly and retest.
If the door switch assembly has been
replaced and dryer still does not start,
replace the machine control electron-
ics.
•
•
