Kenmore KM1000, Use & Care Manual

Page: 14 / 28

Using Your Water Optimizer
Using Your Water Optimizer 10
on the
N
Dispense Button . Water (of selected temperature mode) will continue to
dispense until button is released, or 10 minutes has elapsed.
QuickFill Mode , when triggered, will dispense water for 10 seconds (this time is
customizable, see “Customizing QuickFill Mode” on page 10 ), and then stop.
It is active by default, and can be toggled by pressing
M
QuickFill Mode Button .
To dispense water using QuickFill Mode (when active), simply press the
N
Dispense Button .
ConstantFill Mode , when triggered, will continuously dispense water ‘hands-free’
until it is disengaged (or 90 seconds has elapsed). It can be toggled by pressing
the
M
QuickFill Mode Button once, after which the button’s light will shutoff,
indicating ConstantFill Mode is active. Once it has been selected, simply press the
N
Dispense Button
to start dispensing water, and then press it again to stop dispensing.
Customizing QuickFill Mode
QuickFill Mode can be customized to fit your favorite cup, bottle, or other container. Be
aware that this function is controlled by a timer, and may vary based on fluctuations in your
water sources pressure (i.e. when your sink is running if that is your source). Complete the
following instructions to customize the time. Minimum required duration of 6 seconds.
1. Place your desired container (empty) underneath the
O
Water Dispenser Nozzle .
2. Press and hold the
M
QuickFill Mode Button for 5 seconds. Button begin to flash.
3. Press and release the
N
Dispense Button
. Water will begin dispensing.
4. Once your container has reached the desired fill level, press and release the
N
Dispense Button to stop water from dispensing.
5. Finally, press and release the
M
QuickFill Mode Button
to save your new fill time.
You’re all set!
Controlling Dispenser Light
Your Water Optimizer is equipped with a
II
Dispenser Light . It has 3 different modes