Kenmore KM1000, Use & Care Manual

Page: 13 / 28

Using Your Water Optimizer 9
Using Your Water Optimizer
This guide will explain how to use, maintain, and troubleshoot your new Water Optimizer.
Be sure to complete all of the applicable instructions in the Installation Guide,
included with your Optimizer prior to using the appliance.
Powering On/Off Your Optimizer
Be sure to never plug in your Optimizer, or power on either temperature mode
before you’ve connected a proper water source, and enabled water flow.
1. To power on your Water Optimizer, simply plug in
Z
110v Power Cord into a 110 volt
electrical outlet. To power off, unplug the appliance.
2. To power on the
cooling system
, flip the green
X
Cold Mode Power Switch
(on the
left) up, into the on position. To power off, flip back down.
3. To power on the heating system , flip the red
Y
Hot Mode Power Switch (right) up,
into the on position. To power off, flip back down.
Dispensing Water
Dispensing water can be accomplished by pressing 1 - 3 buttons, depending on the situation.
What temperature of water is dispensed (temperature modes), and the amount of water
that is dispensed (dispense modes) can be selected by pressing the temperature and
dispense mode buttons. By default, your Water Optimizer is set to (and will always return
to)
QuickFill Mode
/
Press-To-Fill Mode,
and
Cold Temperature Mode
, which can
simply be triggered by pressing or holding the
N
Dispense Button .
1. For non-default usage, start by selecting your temperature mode of choice, by
pressing one of the following buttons.
J
Hot Dispense Mode Button - Child Safety Lock function requires dispense
button to be pressed within 5 seconds of selecting hot mode.
K
Ambient Dispense Mode Button
L
Cold Dispense Mode Button - DEFAULT
Next, select your preferred dispense mode by following the relevant instructions
for that specific mode.
Press-To-Fill Mode can be triggered by simply pressing and holding your finger down