6
Location Requirements
Selecting the proper location for your washer improves
performance and minimizes noise and possible washer “walk.”
Your washer can be installed under a custom counter, or in a
basement, laundry room, closet, or recessed area. See “Drain
System.”
Companion appliance location requirements should also be
considered. Proper installation is your responsibility.
You will need
■
A water heater set to deliver 120°F (49°C) water to the
washer.
■
A grounded electrical outlet located within 6 ft (1.8 m) of
where the power cord is attached to the back of the washer.
See “Electrical Requirements.”
■
Hot and cold water faucets located within 4 ft (1.2 m) of the
hot and cold water fill valves, and water pressure of
20-100 psi (137.9-689.6 kPa).
■
A level floor with a maximum slope of 1" (2.5 cm) under entire
washer. Installing the washer on soft floor surfaces, such as
carpets or surfaces with foam backing, is not recommended.
■
A sturdy and solid floor to support the washer with a total
weight (water and load) of 400 lbs (180 kg).
Do not operate your washer in temperatures below 32°F (0°C).
Some water can remain in the washer and can cause damage in
low temperatures.
Installation clearances
■
The location must be large enough to allow the washer door
to be fully opened.
■
Additional spacing should be considered for ease of
installation and servicing. The door opens more than 90°, and
it is not reversible.
■
Additional clearances might be required for wall, door, and
floor moldings.
■
Additional spacing of 1" (2.5 cm) on all sides of the washer is
recommended to reduce noise transfer.
■
Companion appliance spacing should also be considered.
Washer Dimensions
Recommended installation spacing for custom
undercounter installation
The dimensions shown are for the recommended spacing.
Custom undercounter installation - Washer only
Recommended installation spacing for recessed or
closet installation, with or without a pedestal
The dimensions shown are for the recommended spacing.
Recessed area or closet installation
*Min. top and bottom air openings for closet door.
Recessed or closet installation - Washer on pedestal
Door is not reversible.
27"
(68.6 cm)
50
¹⁄₄
"
(127.6 cm)
36"
(91.4 cm)
30
¹⁄₂
"
(77.5 cm)
A. Side view - closet or confined area
B. Closet door with vents
A. Recessed area
B. Side view - closet or confined area
1"
(2.5 cm)
1"
(2.5 cm)
37" min.
(93.9 cm)
27"
(68.6 cm)
A
B
3"
(7.6 cm)
3"
(7.6 cm)
1"
(2.5 cm)
4"
(10.2 cm)
30
¹⁄₂
"
(77.5 cm)
48 in.
2
*
(310 cm
2
)
24 in.
2
*
(155 cm
2
)
14"* max.
(35.6 cm)
1"
(2.5 cm)
30
¹⁄₂
"
(77.5 cm)
1"
(2.5 cm)
1"
(2.5 cm)
27"
(68.6 cm)
4"
(10.2 cm)
A
B
14"* max.
(35.6 cm)
Summary of Contents for HE2 Plus 110.4751 Series
Page 27: ...27 Notes ...
