11
Setting the Dual Ring Burner
The Dual Ring Burner has two rings of flame that you can control for two different heat
levels, one for small and one for large cookware.
Large Cookware Operation (Figure 1; Zone A & B)
1. Place a large cooking utensil centered over the dual surface Burner Grate.
2. Push the surface control knob down and turn
counterclockwise
out of the OFF
position.
3. Release the knob and rotate to the
LITE
position (Figures 2 & 3). Note: All electronic
surface ignitors will spark at the same time. However, only the selected surface
Burner will lite.
4.
visually check that the burner has lit.
5. When the burner is lit, continue to turn the control knob
counterclockwise
between
the HI position and the MED position to adjust to the desired flame size for both
burners together (figure 1).
DO NOT
cook with any of the surface control knobs in
the LITE position (The electronic ignitor will continue to spark if the knob is left in the
LITE position).
Simmering Operation (Figure 1; Zone A)
1. Place a small cooking utensil centered over the dual surface Burner Grate.
2. Push the surface control knob in and turn
counterclockwise
out of the OFF position
(See Figures 2 & 3).
3. Release the knob and rotate to the
LITE
position. Note: All electronic surface
ignitors will spark at the same time. However, only the Dual Burner will ignite.
4.
visually check that zone A & B of dual burner has lit.
5. Continue to turn the gas control knob counterclockwise past the MED position; zone
B will turn off. Adjust the simmer flame size by turning the control knob between the
MED position to the LO position
.
DO NOT
cook with the surface control knob in the
LITE position (The electronic ignitor will continue to spark if the knob is left in the
LITE position).
B
A
Figure 1
Figure 2
Setting Surface Burner Controls
Figure 4
Figure 3
Turn
Counterclockw
ise
OFF
HI
turbo boil
LO
simmer
MED
LITE
11
