10
Setting Surface Controls
(cont’d)
Figure 1
Single Elements
Operating Single Radiant Surface Elements
The cooktop has 3 SINGLE radiant surface elements (figure 1): the
RIGHT REAR
position,
the
LEFT REAR
position and the
LEFT FRONT
position.
To Operate the Single Radiant Surface Elements:
1. Place correctly sized cookware on the radiant surface element.
2. Touch and hold the
pad for the desired element position until a beep is heard.
The display will show
“ -- ”
.
Note:
If no further pads are touched within 10 seconds the request to power the
element ON will clear.
3. Touch
Hi
pad once to turn ON the power level to HI. Touch
Lo
pad once for Lo power
level (See Figure 2).
4. Each touch of the
Hi
or
Lo
pad will decrease or increase the power level from
9.0
through
3.0
by .5 increments. Simmer power levels between
3.0
and
1.2
will decrease
or increase by .2 increments.
Lo
is the lowest power level available.
Note:
The power level may be adjusted at any time while the element is ON.
5. When cooking has been completed touch the
pad once to turn the element
OFF.
Each surface element provides a constant amount of heat at each setting. A glowing
red surface heating area extending beyond the bottom edge of the cookware indicates
the cookware is
too small
for the surface heating area.
Note:
The
Hot Surface
message will be displayed on the control panel as soon as
the element is hot and will remain ON until the heating surface area has cooled
sufficiently.
Radiant surface elements may appear to have cooled after they have been turned off.
The glass surface may still be hot
and burns may occur if the glass surface is touched before it has
cooled sufficiently.
Do not place plastic items such as salt and pepper shakers, spoon holders or plastic
wrappings on top of the range when it is in use.
These items could melt or ignite. Potholders, towels
or wooden spoons could catch fire if placed too close to the surface elements.
Figure 2
Summary of Contents for Elite 790.9751 Series
Page 42: ...42 Notes ...
