EN-
GLISH
9
PLACING THE DISHWASHER
1) Straighten and position the hot water supply line and
the electrical supply cable as shown in Figure 14 so
that they will align with their channels under the
dishwasher base.
2) Position the dishwasher close enough to the
enclosure so that you can run the dishwasher drain
hose to the under-sink drain connection. Make certain
that the hot water supply line and the electrical supply
cable are in their channels under the dishwasher base,
as shown in Figure 15, letter A.
3) Place the dishwasher directly in front of the enclo-
sure.
4) Perform a level check as shown in Figure 15. Adjust
the rear leveler by turning the center screw at the front
of the dishwasher, as shown in Figure 16, letter B.
Turning the screw clockwise raises the rear of the
dishwasher. Adjust the front levelers by turning them
with a screwdriver, as shown in Figure 16, letter C.
Turning the levelers to the right raises the dishwasher.
If additional height is needed, shims may be added
under the leveler feet.
5) Push the dishwasher into the enclosure.
Placing the Dishwasher
Figure 14
Figure 15
Figure 16
21"
(533mm)
14"
(355mm)
A
B
C
Electrical
Supply
Cable
Hot Water
Supply Line
Summary of Contents for Dishwasher
