Kenmore 795.78302.800, Service Manual

Page: 8 / 66

3-3 FAN AND FAN MOTOR
1. Remove the freezer shelf. (If your refrigerator has an
icemaker, remove the icemaker first)
2. Remove the plastic guide for slides on left side by
unscrewing phillips head screws.
3. Remove the grille by removing one screw and pulling the
grille forward.
4. Remove the Fan Motor assembly by loosening 2 screws.
5. Pull out the fan and separate the Fan Motor and Bracket.
3-4 DEFROST CONTROL ASSEMBLY
Defrost Control assembly consists of Defrost Sensor and
FUSE–M.
The Defrost Sensor works to defrost automatically. It is
attached to the metal side of the Evaporator and senses its
Temperature.
Fuse-M is a safety device for preventing over-heating of
the evaporator area when defrosting.
1. Pull out the grille assembly. (Figure 12)
2. Separate the connector with the Defrost Control
assembly and replace the Defrost Control assembly
after cutting the tie wrap. (Figure 13)
3-5 LAMP
3-5-1 Refrigerator Compartment Lamp
3-5-2 Freezer Compartment Lamp
3-6 REFRIGERATOR CONTROL BOX
1. First, remove all shelves in the refrigerator, than remove
the Refrigerator control Box by loosening 2 screws.
2. Remove the Refrigerator Control Box by pulling it
downward.
3. Disconnect the lead wire on the right position and
separate the lamp sockets.
3-7 MULTI DUCT
1. Remove the upper and
lower caps by using a flat
screwdriver, and remove 2
screws. (Figure 17)
2. Disconnect the lead wire
on the bottom position.
- 8 -
GRILLE ASSEMBLY
Figure 12
DEFROST-CONTROL
ASSEMBLY
Figure 13
Figure 14
Figure 15
CONTROL BOX
COVER LAMP
Figure 17
Figure 18
GRILLE
FAN MOTOR
FAN
BRACKET
MOTOR
Figure 11
At 72°C, it turns the Defrost Heater off.
3. Be sure to retie the wires when reassembling after service.
1. Unplug the power cord from the outlet.
2. Remove refrigerator shelves.
3. Release the hooks on the front of the light shield with
the help pf a flat screwdriver and pull the shield down to
remove it.
4. Turn the bulb counterclockwise.
5. To assemble, first insert the hooks at the back and then
push up the light shield.
1. Unplug refrigerator or disconnect power.
2. Reach behind light shield to remove bulb.
3. Replace bulb with a wattage indicated in the
refrigerator section, as shown in picture 1.
4. Plug in refrigerator or reconnect power.
Figure 16
1 1