- 11 -
Remove screw from water tube clip.
Reattach to the left side as shown below.
Important: Insert the wire harness into the base as
shown below.
Turn refrigerator door upside down on a non-scratch
surface and remove cap cover located on the left side
using a flat-head screwdriver.
Then attach the cap cover on the opposite side.
Cap cover is force fitted and holds the electrical
harness.
Loosen the 2 screws and remove the door Closer/Stop.
Door Closer/Stop
Fig. 41
Take Door Closer/Stop and flip it over. Line up screw holes
and screw it into left side of door bottom.
Turn door upright. It is now ready for re-attaching.
Fig. 42
Insert the water dispenser tube into the left channel at the
base of the dispenser cavity until it comes out of the bottom
left corner of door.
Insert and reattach tube guide.
Fig. 43
tube guide
screw
left channel right channel
tube
Reconnect the wire connector to the back of the dispenser cover,
then insert the dispenser cover top clips into the slots in the top
on the dispenser cavity. Make sure that the dispenser tube is
lined up with the hole in the dispenser cover. Press against
cover firmly to reattach.
