Kenmore 795. 72062.21 series, Service Manual

Page: 9 / 98

- 9 -
3-5 DEFROST CONTROL ASSEMBLY
3-5-1 DEFROST CONTROL ASSEMBLY(Freezer Room)
3-5-2 DEFROST CONTROL ASSEMBLY
(Refrigerator Room)
Figure 1
Figure 2
GRILLE ASSEMBLY
DEFROST-CONTROL
ASSEMBLY
Figure 1
Figure 2
Multi Duct
DEFROST-CONTROL
ASSEMBLY
* Fan Motor Replacement
1) Remove guide rail on left side.
2) Remove Caps and 2 screws under Caps
3) Disconnect the lead wire
4) Grip both side of Multi Duct, pull it out.
4) Remove 4 screws of Shroud Refrigerator on back of
Multi Duct.
5) Remove Shroud Refrigerator and Replace Fan Motor.
(1) (2)
(3) (4)
(5) (6)
Defrost Control assembly consists of Defrost Sensor and
FUSE-M.
The Defrost Sensor works to defrost automatically.
It is attached to the metal side of the Evaporator and
senses its temperature.
At 46F(8°C), it turns the Defrost Heater off.
Fuse-M is a safety device for preventing over-heating of the
Heater when defrosting.
1. Pull the Multi Duct (Figure 1)
2. Separate the connector with the Defrost Control
assembly and replace the Defrost Control assembly
after cutting the Tie Wrap. (Figure 2)
Defrost Control assembly consists of Defrost Sensor and
FUSE-M.
The Defrost Sensor works to defrost automatically. It is
attached to the metal side of the Evaporator and senses its
temperature. At 46F(8°C), it turns the Defrost Heater off.
Fuse-M is a safety device for preventing over-heating of
the Heater when defrosting.
1. Pull out the grille assembly. (Figure 1)
2. Separate the connector with the Defrost Control
assembly and replace the Defrost Control assembly after
cutting the Tie Wrap. (Figure 2)
Shroud Refrigerator
Bracket Motor
Fan Motor