29
Setting Oven Controls
When Self Clean is finished:
Use caution when opening the oven door after
self cleaning. The oven may still be very hot and can cause
burns. To avoid possible burns, stand to the side of the oven
when opening the oven door to allow hot air or steam to escape.
The oven bake and broil elements may appear to have cooled
after they have been turned off. The elements may still be hot,
and burns may occur if these elements are touched before they
have cooled.
1.
Cln message will turn off and Hot will appear in display
window (See
Figure 39
).
2. Once the oven has cooled down (about 1 hour) and Hot is
no longer displayed, the door Opn message will appear.
When this message turns off, the oven door may be opened.
Important note:
Attempting to force open the oven door before the door Opn
message is gone from the display can ruin the motor door latch.
3. When the oven interior has completely cooled, wipe away
any residue or powdered ash with a damp cloth or paper
towel.
Important note:
The kitchen area should be well ventilated. Use an open window,
ventilation fan, or exhaust hood during the first self clean cycle
to help eliminate the normal odors associated the initial clean
cycle.
When the clean time finishes, the oven door will remain locked
until the oven has cooled sufficiently. In addition to the clean
time that was programmed, allow about 1 hour for the oven to
cool before opening the oven door. The Self Clean function will
not operate when the oven lockout is active.
Setting Delay Start Self Clean
To start a delay Self Clean with default clean time of 3 hours
and a start time of 9:00 o’clock:
1.
Be sure the clock is set with the correct time of day, the oven
is empty, and all oven racks are removed. Be sure oven door
is completely closed.
2. Press
Delay Start
.
3. Using numeric keys, enter
9 0 0
for time to start.
4. Press
to accept
5. Press
Self Clean
.
6. Press
.
If it becomes necessary to stop Self Clean when active:
1.
Press .
2. If Self Clean has heated the oven to a high temperature,
allow enough time for the oven to cool and the door Opn
message to appear (See
Figure 39
). When this message
turns off, the oven door may be opened.
3. Before restarting Self Clean, be sure to read important
notes below.
Important note:
•
When Self Clean is active, you may check the amount of
clean time remaining by pressing the Self Clean key once.
•
If your clock is set with the (default) 12 hr display mode, the
Delay Start for a Self Clean can only be programmed to
start up to 11 hours and 59 minutes after the time showing in
the display (be sure to set the clock to current time before
programming a delay start). To set a Delay Start Self Clean
to begin 12 or more hours (maximum is 23 hours and 59
minutes) after the time of setting, be sure to first set the
control in the 24 Hr display mode.
•
If Self Clean was active and then interrupted by a power
failure or cancelled before the oven was thoroughly
cleaned, it may be necessary to run another Self Clean
cycle.
•
If the oven temperature was high enough when Self Clean
was interrupted the oven control may not allow another Self
Clean cycle to be set for up to 4 hours.
Figure 38: Door locking (L) and active Clean (R) shown
Figure 39: Hot oven door locked (L) door open message (R).
Summary of Contents for 790.3262 Series
Page 38: ...38 Before You Call ...
Page 39: ......
