11
Turn cycle knob to choose your wash cycle�
8.
Select cycle
9.
Select cycle
modifiers, if desired
Once you select a cycle, the default settings for that cycle will
be lit. Touch the cycle modifiers buttons to change the Wash
Temp, Soil Level, and Spin Speed, if desired� Not all settings are
available with all cycles� Even for cold wash settings, some warm
water may be added to the washer to maintain a minimum
temperature�
NOTE:
Always read and follow fabric care labels instructions to
avoid damage to your items� If not sure on which temperature to
use, refer to the diagram above or select a cooler temperature�
11.
Touch and hold START/PAUSE/Unlock Lid
to begin wash cycle
10
.
Select cycle options
Select any other cycle options you may wish to add, if not
previously set� Some cycles will automatically add certain
options such as Two Rinses. These may be turned off,
if desired�
NOTE:
Not all options are available with all cycles�
Touch and hold START/PAUSE/Unlock Lid button for up to
3 seconds to start the wash cycle. When the cycle has finished,
the COMPLETE indicator will light and the end of cycle signal
will sound (if set)� Promptly remove items when cycle is done
to avoid odor, reduce wrinkling, and rusting of metal hooks,
zippers, and snaps�
Unlocking the lid to add garments
If you need to open the lid to add 1 or 2 missed items:
Touch START/PAUSE/Unlock Lid to pause washer; the lid will
unlock once the washer movement has stopped� This may take
several minutes if the load was spinning at high speed� Then
close lid and touch and hold START/PAUSE/Unlock Lid again
for up to 3 seconds to restart the cycle�
IMPORTANT:
If lid is left open for more than 10 minutes the
water will pump out and F8E6 error code will appear on the
display�
Light soils
Colors that bleed
or fade
Heavy Soils
Whites
Pastels
Moderate soils
Bright colors
Steam model shown
