13
engli
SH
REFRIGERATOR INSTALLATION
REVERSING THE DOORS
1. Remove the refrigerator and freezer doors as described
on pages 11 and 12.
2. After removing one screw and two bolts, remove the
left middle hinge. (Unscrew the screws with the screw-
) and hex holt with the 3/16-in(4.75-mm) hex
wrench.)
3. Remove two screws and front leg cover from the bottom
of the refrigerator.
4. Remove the cap from the back side of the leg cover and
insert it into the opening on the opposite rear side.
5. Remove four bolts and the left and right bottom hinge
assemblies from the bottom of the refrigerator.
6. Unscrew the leg from the right bottom hinge. Using a
5/32-in. (4-mm) hex wrench, separate the hinge shaft
from the right hinge bracket.
7. Turn the right bracket over and reinstall the hinge shaft in
the bracket. Tighten the hinge shaft with the 5/32-in. (4-
mm) hex wrench. Thread the leg back into the opposite
side of the hinge bracket.
8. Reinstall the two bottom hinges on the bottom of the
refrigerator and secure with the four bolts.
NOTE:
These hinges should be installed opposite from
where they were removed.
9. Remove screw and door stopper from the right-bottom
side of the freezer door, flip it, and reinstall it on the left-
bottom side of the freezer door.
10. Remover the cap hinge of right-upper side of the freezer
door, and reinstall it on the left-upper side of the freezer
door.
Cap
Cap
UP
L
R
DA68-01921B.indb 13
2010.3.5 9:26:49 AM
