Kenmore 146.03358410, Use & Care Manual

Page: 26 / 82

26 · 146.03358410
Right Side Searing burner
□
Remove plastic packaging from searing burner valve. Remove searing burner grate from within
searing burner shelf.
□
Connect flat igniter wire tip to the igniter pin on the searing burner valve. (A & B)
□
Remove the 2 pre-installed screws from the valve control stem and set them aside. (C)
□
Loosen the searing burner to insert gas valve. To loosen, remove the screw attaching the
electrode (D) to the shelf and set both aside. Then loosen and remove the two screws holding
searing burner in place (E).
□
Insert the gas valve into the searing burner (F), and insert the valve control stem through the hole
in shelf fascia. (I)
□
Reattach searing burner to side shelf with the 2 previously removed screws (G). Reattach
electrode to side shelf with previously removed screw (H).
□
Install previously removed 2 screws .Note: Do not tighten these 2 screws until the bezel is
attached to fascia and valve face.(I).
□
Attach bezel to facial and valve face with the installed screws .First attach one side key hole of
bezel to the screw ,then attach the other one to the other screw. Make sure the black mark
faces up. Tighten the 2 screws. (J)
□
Push control knob with red indicator mark onto side burner valve stem. (K)
□
Replace searing burner grate. (L)
□
Slide searing burner grease box into the grease box bracket. (M)
□
Connect the round igniter wire tip to the pin on the white electrode protruding from the bottom of
the searing burner shelf. (N)
D
D
A B C
E