5
Figure 8
Figure 9
Figure 10
CLOSE-TO-CEILING INSTALLATION
1. Remove the decorative canopy bottom cover
from the canopy by depressing the three studs
(Fig. 8)
2. Pass the 120-volt supply wires through the
center hole in the ceiling hanger bracket as
shown in Fig. 5.
3. Secure the hanger bracket to the ceiling outlet
box with the screws and washers provided with
your outlet box.
4. Place the ceiling canopy over the collar at the
top of the motor. Align the mounting holes with
the holes in the motor and fasten using the
screws and lock washers provided (Fig. 9).
5. Tighten the mounting screws securely. (Fig. 9)
WARNING:
Failure to completely tighten the three
screws in step 5 could result in fan loosening and
possibly falling.
6. Hang the fan on the hook of the hanger bracket.
Be certain that the canopy is fully locked into
hook as shown in Fig. 10. This will allow you to
make the electrical connections.
Canopy bottom cover
Hook
Screw and lock washer
Canopy
Canopy
Collar
