6
Figure 11
Figure 12
9. ATTACHING THE FAN
BLADES
CAUTION:
Make sure all screws are
tightened securely.
Step 1. Attach the fan blades to the blade holders
by using three screws and fiber washers as
shown in Figure 11. Start a screw into the blade
holder, do not tighten. Repeat for the 2 remaining
screws and washers.
Step 2. Tighten each screw securely starting with
the center screw. Make sure the blade is straight.
Step 3. Attach the blade assembly to the fan
motor assembly by tightening the two screws
previously the package hardware. (Figure 12)
8. FINISHING THE
INSTALLATION
Step 1. Tuck connections neatly into ceiling
outlet box.
Step 2. Slide the canopy up to hanger bracket
and place the key hole on the canopy over the
screw on the hanger bracket, turn canopy until
it locks in place at the narrow section of the
key holes. (Fig.10)
Step 3. Align the circular hole on canopy with
the remaining hole on the hanger bracket,
secure by tightening the two set screws.
Note:
Adjust the canopy screws as necessary until
the canopy and canopy cover are snug.
WARNING:
Make sure tab at bottom of
hanger bracket is properly seated in groove of
hanger ball before attaching canopy to
bracket. Failure to properly seat tab in groove
could cause damage to electrical wiring.
Figure 10
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
Screws
Fiber washers
Blade
Blade holder
Screws
Fan motor assemby
Blade assembly
