Ken 59.480, Instruction Manual

Page: 31 / 44

Section/page:12.4
Trouble shooting/error codes
KEN DW 412
Subject to alterations 17/9/2013
NB! Remedying an error that requires the use of tools to remove the
machine cover plates may only be carried out by specially trained,
technical staff.
Display/error #55 - #”200 Cause Remedial action
#55 DRAIN FAULT
(only if drain pump is
installed)
1. Drain blocked.
2. Defective drain pump. To be cleaned.
To be repaired.
#65 HOOD FAULT
Input has at a time during the wash/
rinse period been without signal.
1. Poor wire connection/contactor
2. Reed contakt defect or wrongly
adjusted.
To be repaired.
To be replaced or adjusted to make
sure that it does not break e.g. by an
untimely attempt to open the hood.
#76 DEF. THERMOSENSOR
WASH TANK
Thermal-sensor in wash tank
short-circuited or disconnected.
1. Error in connection between
thermal-sensor TS1 and input.
2. Defective thermal-sensor TS1.
Wire to be repaired.
To be replaced.
#77 DEF. THERMOSENSOR
RINSE TANK
Thermal-sensor in rinse tank
short-circuited or disconnected.
1. Error in connection between
thermal-sensor TS2 and input.
2. Defective thermal-sensor TS2.
Wire to be repaired.
To be replaced.
#85 HOOD SECURITY ENABLED
1. Some is preventing for automatic
closing of hood.
2. Error at microswitch for security.
3. Error at lift motor.
Checked.
Adjusted / replaced.
Repared / replaced.
#86 HOOD BLOCKED
1. Some is preventing for automatic
closing of hood.
2. Error at microswitch for
security.
3. Error at lift motor.
Checked.
Adjusted / replaced.
Repared / replaced.
#200 INT. SW FAULT
Defective control module.
1. Control module is broken. Call in a service technician.