X8 SuperSnake GT02XW
Operating manual - EN
2.3 Feed roll pressure adjustment
Adjust the feed roll pressure with the adjustment roller mounted on the pressure arm. The load applied
should be sufficient to overcome a light braking force applied by hand to the filler wire as it exits the welding
gun contact tip.
For smaller diameter and soft filler wires, less feed pressure is required. Refer to the table in the end of
this chapter for further guidance.
1.
Release the pressure arm by lifting it up.
2.
Turn the roller adjuster on the pressure arm to adjust the roll pressure. A graduated scale next to the
adjustment roller indicates the pressure load in newtons (N). For the correct amount of pressure, refer to
the table in the end of this section.
© Kemppi
11/35
Rev. 1901