
EN
Removing outlet tube
Release pressure tension arm. Push the outlet tube out of its housing with a piece of filler wire.
Wire feed rolls
GT 02C and DuraTorque
plastic
ø mm
lower
upper
Fe, Ss, (Al, Mc, Fc)
V-groove
0.6
W001045
W001046
0.8 – 0.9
W001047
W001048
1.0
W000675
W000676
1.2
W000960
W000961
Fc, Mc, (Fe)
V-groove, knurled
1.0
W001057
W001058
1.2
W001059
W001060
Al, (Fe, Fc, Mc Ss)
U-groove
1.0
W001067
W001068
1.2
W001069
W001070
For aluminium filler wires
select the correct feed roll type from the chart supplied and adjust
for the minimum pressure necessary for reliable filler wire drive without deformation of the
wire itself.
For flux-cored filler wires
select a knurled feed roll to achieve better wire grip.
NOTE!
Slight slippage is recommended in the case of aluminium filler wires. This ensures that the
soft wire is not deformed and flattened and that the feed rolls skid over the soft wire if it stops when
passing through the gun liner or contact tip.
For aluminium and stainless steel filler wires
, always use Kemppi DL Chili gun liners.
These liners are especially developed by Kemppi and significantly reduce friction losses, so
improving welding performance and quality.
NOTE!
Mount the lower feed roll, ensuring that the pin on the shaft fits in the cut on the feed roll.
17
© Kemppi Oy / 1442