
EN
NOTE!
The chassis is designed to provide stability in the upright position, when loaded with or
without a gas cylinder. Reasonable effort is required to raise and lower the machine and cylinder to
a position of movement. If you are light in weight or in any way unsure about moving the machine
and cylinder, you should consider an alternative method or process. A local Health and Safety audit
and risk assessment may be necessary before heavy or new equipment is taken into use, including
the use for carrying or transporting compressed shielding gas cylinders.
NOTE!
In all cases the chassis design is not recommended for lifting its weight clear of the
ground by the handles or any other means, with or without a gas cylinder loaded in place. When
transporting the machine between sites, welding gas cylinders must be removed from the chassis,
secured and transported by other means.
4.
BEFORE YOU START USING THE UNIT
4.1 Installing filler wire
Kempact RA is designed for 300 mm wire spools and the following filler wire types:
•
solid wires
•
flux-cored wires
•
self-shielded flux-cored wires
•
stainless steel wires
•
aluminium wires
•
brazing wires
When choosing appropriate filler materials, remember that the wire must have approximately
the same melting point as the base material to be welded. MIG brazing process is an exception
to this rule.
NOTE!
When changing the filler wire, always check that the feed rolls, their groove shape and size
and the wire liner inside the welding gun cable are suitable for the wire you are using. Also check
that you are using the correct polarity for the filler wire
.
11
© Kemppi Oy / 1442