14
PARTS AND SERVICE
Replacement parts can be obtained through your local Kodiak Marine engine dealer. Kodiak
dealers are equipped to perform major and minor repairs. They hope to see all of your
maintenance and service needs are quickly and courteously completed. Feel free to contact KEM
Equipment Inc./Kodiak Marine regarding your experiences with our service dealers, good or bad.
The engine model number and serial number will be required when seeking information and/or
ordering parts. There is a list of service dealers located near the end of this manual. Or you can
log on to
www.kemequipment.com
for the most up to date service dealer list.
Some part numbers commonly used in general maintenance are listed in the LT4 Engine Quick
Reference table on page 21 of this manual.
SERVICE LITERATURE
By contacting our Parts department at 503-692-5012, you can purchase parts and service
manuals for Kodiak Marine engines. A parts book and a digital copy of this manual are also
available online at kemequipment.com
WARNING:
The bilge and engine compartment can accumulate explosive fumes. The bilge
blower will evacuate the fumes. The bilge blower must be run for a minimum of 10 minutes prior to
cranking the engine.
WARNING:
Do not start or run the engine in a closed or poorly ventilated area where exhaust
gases may accumulate. All internal combustion engines give off various fumes and gases while
running. Avoid breathing these gases as they may contain poisonous carbon monoxide and other
gases, which can endanger your health or life if inhaled steadily for a few minutes.
CAUTION
:
If the engine stalls or falters during starting, wait 3 to 4 seconds before re-
engaging the starter. This will prevent possible damage to the starter or the engine. Do NOT operate
the starter for periods longer than 5-8 seconds at a time. An interval of at least 1 minute should be
observed between cranking periods to protect the starter from overheating.
Summary of Contents for KODIAK MARINE LT4 SUPERCHARGED
Page 2: ...2 ...
