30
b.) Adjustment:
Up
and
Down
When the band wheel is skewed and the upper part (PICTURE 3) or lower part (PICTURE 4) of
the wheel is too close to the protective cover.
MEASURE
If the band wheel is skewed as shown in PICTURE 3, loosen the top adjustment bolt (# 7) with
the 19mm wrench and adjust it up until you have the correct height. If the band wheel is
skewed as shown in PICTURE 4, the bolt is adjusted downwards. It is important that the upper
and bottom nuts are adjusted simultaneously. Both should be pulled the same number of
turns .
6.) Perform the previous steps if fine tuning is needed when saw band is already tensed. Spin
the band wheels and check the distance between the wheels and protection cover
7.) When the band wheels is completely-aligned, tighten all bolts
PICTURE 3
PICTURE 4
