KELCH KENOVA set Line V224, Operating Instructions Manual

Page: 34 / 209

2 Safety
Seite 10 KENOVA set Line V224

Kelch GmbH 2013
Kelch GmbH • Werkstraße 30 • D-71384 Weinstadt-Endersbach • Tel. (+49)7151 20522 0 • Fax (+49)7151 20522 11 • info@kelchgmbh.de
2.8 Special Dangers
2.8.1 Electrical Energy
Danger of death if the unit is used incorrectly

The tool presetter must not be operated if the case is open

The unit must not be operated in explosive atmosphere

The unit must not be exposed to condensation or liquids

Immediately switch off the unit if any of the following defects are detected:

Loose cable connections

Incorrect isolation

Burned cables

Other defects which affect the electrical safety of the tool presetter

Only switch on and operate the unit once all the defects have been eliminated

The electrical connection of the tool presetter to the power supply and work on the
electrical equipment has to be performed by qualified personnel. Relevant VDE
regulations or the regulations and provisions that apply at the installation site
should always be observed
2.8.2 Compressed Air Supply
Work on the compressed air system should only be carries out by qualified staff, taking
into account the regulations and provisions that apply at the installation site.
Kelch GmbH
shall not accept any liability if these regulations and provisions are
contravened.
Pressure hoses and cables and screw fastenings must be checked regularly to ensure
they are intact and must be replaced even if they are slightly damaged.
2.9 Opening the Case
The tool adjusting device’s case should only be opened by qualified
Kelch GmbH
staff!
Kelch GmbH
shall not accept any liability if this is contravened.