Series 2600B System SourceMeter® Instrument Reference Manual
Section 7: TSP command reference
2600BS-901-01 Rev. B / May 2013
7-251
Also see
smuX.trigger.source.action
(on page 7-246)
smuX.trigger.source.linearY()
(on page 7-248)
smuX.trigger.source.listY()
(on page 7-249)
Sweep operation
(on page 3-20)
smuX.trigger.source.set()
This function sets the source event detector to the detected state.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Function
Yes
Usage
smu
X
.trigger.source.set()
X
Source-measure unit (SMU) channel (for example,
smua.trigger.source.set()
applies to SMU channel A)
Details
This function sets the source event detector to the detected state.
The SMU automatically clears all event detectors when the
smu
X
.trigger.initiate()
function is executed.
This function should be called after the sweep is initiated. If the event detectors are configured to clear
automatically because the
smu
X
.trigger.autoclear
attribute is set to
smu
X
.ENABLE
, make sure that
smu
X
.trigger.source.set()
is issued after the SMU has entered the trigger layer.
Also see
smuX.trigger.arm.set()
(on page 7-233)
smuX.trigger.autoclear
(on page 7-235)
smuX.trigger.endpulse.set()
(on page 7-237)
smuX.trigger.initiate()
(on page 7-240)
smuX.trigger.measure.set()
(on page 7-241)
Triggering
(on page 3-32)
smuX.trigger.source.stimulus
This attribute defines which event causes the source event detector to enter the detected state.
Type
TSP-Link accessible
Affected by
Where saved
Default value
Attribute (RW)
Yes
SMU reset
Instrument reset
Recall setup
Not saved
0
Usage
eventID
= smu
X
.trigger.source.stimulus
smu
X
.trigger.source.stimulus =
eventID
eventID
Set to the event that triggers the end pulse source off action
X
Source-measure (SMU) channel (for example,
smua.trigger.source.stimulus
applies to SMU channel A)
Summary of Contents for System SourceMeter 2601B
Page 841: ......