2600S-901-01 Rev. C / January 2008
Return to
1-19
Series 2600 System SourceMeter® Instruments Reference Manual
Section 1: Getting Started
Menu types
Many aspects of operation are configured through menus. There are two types of menus. Refer to
the
topic in this section for more details on using menus.
Main menu
The main menu is summarized in
, along with the reference for each main selection.
To access the menu items shown in
, press the
MENU
key, and then make your
selection.
NOTE Use the menu options in
with v1.4.0 or higher.
Table 1-3
Main menu
Menu selection
Description
Reference
Setup
SAVE
RECALL
POWERON
Saves and recalls user and factory setup options.
Saves user setup options.
Recalls user setup options.
Sets the default configuration.
GPIB
ADDRESS
ENABLE
Configure the GPIB interface options.
Configure the address for the GIPB interface.
Enables and disables the GPIB interface.
RS232
ENABLE
BAUD
BITS
PARITY
FLOW-CTRL
Controls the options for the RS232 interface.
Use to enable and disable the RS232 interface.
Set the baud rate.
Configure the number of bits.
Set the parity.
TSPLINK
NODE
RESET
An alternate way to configure the instrument for
TSP-Link.
Selects the instrument node identifier.
Use to reset the TSP-link network.
DISPLAY
NUMPAD
TEST
Use to perform the display tests.
Enables and disables the NUMPAD.
Runs the display test.
DIGOUT
DIG-IO-OUTPUT
WRITE-PROTECT
Preforms display test patterns.
BEEPER
ENABLE
DISABLE
Controls the key beeps.
Enables the key beeps.
Disables key beeps.