Document number: S46-901-01 Rev. F / March 2011
1-5
S46/S46T/S46L Microwave Switch System Instruction Manual
Section 1: General Information
NOTE
Refer to
for detailed connection information.
Installation
You can either mount the S46/S46T/S46L in a rack using the supplied rack-mounting hardware, or
operate it on a bench by installing the supplied feet, as described in
.
Rack mounting
The S46/S46T/S46L can be mounted in a standard 19-inch rack. The hardware necessary to
install the instrument in a rack is supplied with the S46/S46T/S46L.
Rack-mount kit
The S46/S46T/S46L is supplied with a Model 4288-7 rack-mount kit, which mounts the instrument
in a standard 19-inch rack. This kit includes rear brackets to provide additional support for the
instrument.
Rack-mount procedure
WARNING
Make sure the S46/S46T/S46L is turned off, the line cord is
disconnected, and it is not connected to any external circuitry.
The power supply cord must be used as the mains disconnecting
device. The plug should be located in close proximity to the user
and remain readily accessible at all times.
To install the S46/S46T/S46L in the rack:
1.
Select a location in the rack. The instrument fills 3.5 inches of vertical space.
2.
Using
as a guide, install two retaining clips on the left front rail. Slide each
retaining clip over a mounting hole so that the captive nut is positioned on the inside of the
rack cabinet. Install two retaining clips on the right front rail using the same procedure.
Figure 1-1
Rack preparation
3.
If installed, remove the four feet from the bottom of the S46/S46T/S46L. Retain these feet
for future use.
4.
Position the S46/S46T/S46L in the rack, and loosely attach the front panel to the rack rails
using the four supplied dress screws.
1.75”
Left Front
Rack Rail
Retaining
Clips with
Nuts
