Keithley 7037, Instruction Manual

Page: 24 / 72

Card Connections and Installation
4-5
Figure 4-6
Digital I/O input pull-up resistance selection
Multi-pin (mass termination) connector
card
Since connections to external circuitry are made at the 96-pin
male DIN bulkhead connector, there is no need to separate
the connector card from the relay card. If the connector card
is separated from the relay card, carefully mate them
together. Make sure to handle the cards by the edges and
shields to avoid contamination.
Keithley has a variety of cable and connector accessories
available to accommodate connections from the connector
card to test instrumentation and DUTs (devices under test).
In general, these accessories, which are summarized in
Table 4-1, utilize a round cable assembly for connections.
Terminal identification for the DIN connector of the multi-
pin connector card is provided by Table 4-2 and Figure 4-7.
This connector will mate to a 96-pin female DIN connector.
Jumper
Down Up
A. Pull-down Resistance
Jumper
Down Up
B. Pull-up Resistance Selected
Table 4-1
Mass termination accessories
Model Description
7011-KIT-R 96-pin female DIN connector and hous-
ing for round cable (provided with the
Model 7037 card).
7011-MTC-2 Two-meter round cable assembly termi-
nated with a 96-pin female DIN connec-
tor on each end.
7011-MTR 96-pin male DIN bulkhead connector.