1-2
1.7
Unpacking and inspection
1.7.1 Inspection for damage
The Model 7016A is packaged in a re-sealable, anti-static
bag to protect it from damage due to static discharge and
from contamination that could degrade its performance. Be-
fore removing the card from the bag, observe the precautions
on handling discussed below.
1.7.2 Handling precautions
• Always grasp the card by the side edges and covers. Do
not touch the board surfaces or components.
• After removing the card from its anti-static bag, inspect
it for any obvious signs of physical damage. Report any
such damage to the shipping agent immediately.
• When the card is not installed in a switching main-
frame, keep the card in its anti-static bag, and store it in
the original packing carton.
1.7.3 Shipment contents
The following items are included with every Model 7016A
order:
• Model 7016A 50
Ω
2GHz Multiplexer Card
• Model 7016A Instruction Manual
• Additional accessories as ordered
1.8
Instruction manual
If an additional Model 7016A Instruction Manual is re-
quired, order the manual package, Keithley part number
7016A-901-00. The manual package includes an instruction
manual and any pertinent addenda.
1.9
Repacking for shipment
Should it become necessary to return the Model 7016A for
repair, carefully pack the unit in its original packing carton
or the equivalent, and include the following information:
• Advise as to the warranty status of the card.
• Write ATTENTION REPAIR DEPARTMENT on the
shipping label.
• Fill out and include the service form located at the back
of this manual.
1.10 Recommended accessories
Recommended cables and terminating resistors are covered
below. These items are not stocked by Keithley and must be
obtained from other sources.
1.10.1 Connecting cables
The following cable type is recommended for making input/
output connections to the Model 7016A: RG223/U.
Other 50
Ω
cables may be used, but keep in mind key param-
eters as such as maximum outside diameter, attenuation over
the desired frequency range, flexibility, and shield type. See
paragraph 3.5 in Section 3 for more information on cable pa-
rameters.
1.10.2 Terminating resistors
The following terminating resistor is recommended for use
with the Model 7016A:
Type:
Plug Dummy Load
Manufacturer:
Johnson Components
Part number:
131-3801-811
Nominal resistance:
50
Ω
Power dissipation:
2W