Return to
Figure 5-2
IEEE-488 connections
Instrument
Controller
Instrument
Instrument
Connect the Model 7002-HD to the IEEE-488 bus as follows:
1. Line up the cable connector with the connector located on the rear panel.
The connector is designed so that it will fit only one way.
the location of the IEEE-488 connector on the instrument.
2. Tighten the screws securely, but do not overtighten them.
3. Add additional connectors from other instruments, as required.
4. Make certain that the other end of the cable is properly connected to the
controller.
Note that the IEEE-488 bus is limited to a maximum of 15 devices, including the
controller. The maximum cable length is 20 meters, or two meters times the num-
ber of devices, whichever is less. Failure to observe these limits may result in
erratic bus operation.
Summary of Contents for 7002-HD
Page 80: ...A Specifications...
Page 82: ...B Status and Error Messages...