Keithley 2651A, Reference Manual

Page: 505 / 800

Model 2651A High Power System SourceMeter® Instrument Reference Manual Section 7: Command reference
2651A-901-01 Rev. A / March 2011 7-197
Details
This attribute sets the size of the stack used for filtered measurements.
Example
smua.measure.filter.count = 10
Sets the filter count for SMU Channel A to 10.
Also see
reset() (on page 7-151)
setup.recall() (on page 7-170)
smuX.measure.filter.enable (on page 7-197)
smuX.measure.filter.type (on page 7-198)
smuX.reset() (on page 7-209)
Filters (on page 3-3)
smuX.measure.filter.enable
This attribute enables or disables filtered measurements.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW) Yes Instrument reset
SMU reset
Recall Saved setups smuX.FILTER_OFF
Usage
filterState = smu X .measure.filter.enable
smu X .measure.filter.enable = filterState
filterState
The filter status. Set to one of the following values:
0
or
smu X .FILTER_OFF
: Disables the filter
1
or
smu X .FILTER_ON
: Enables the filter
X
SMU channel (for example,
smua.measure.filter.enable
applies to SMU
Channel A).
Details
This attribute enables or disables the filter.
Example
smua.measure.filter.enable = 1
Enables the filter for SMU Channel A. Alternatively, the
value 1 may be replaced with
smua.FILTER_ON
.
Also see
reset() (on page 7-151)
setup.recall() (on page 7-170)
smuX.measure.filter.count (on page 7-196)
smuX.measure.filter.type (on page 7-198)
smuX.reset() (on page 7-209)
Filters (on page 3-3)